Thomas COVID Supplier BadgeDisplaysResourcesCOVID-19 SUPPLIESGalleryGet a Quote

Hydlar™ Z combines the properties of Nylon with the strength and wear resistance of Kevlar®. This material makes it possible to achieve low abrasiveness without sacrificing low wear rates. Hydlar™ Z’s tough, strong reinforcing material makes the end product extremely wear resistant without excessive galling to mating wear surface.


Contact us today for your fabrication and machining needs!

Request Fabrication/Machining Services
At a Glance

Generic Name
Aramid Reinforced Polyamide

Available In

Start Your Quote

Send us a message:

*Required Fields



Stock Products Properties Applications Advantages Grades


Sheet .25″ to 2″ 24” x 24” CTS Tan

Give us your cut-to-size dimensions. We will precision-cut these plastics to your exact size. Additional sizes and colors available upon request.


Physical PropertiesUnitsASTMResults
Density lb/in³ 1.16
Mechanical PropertiesUnitsASTMResults
Tensile Strength @ yield psi D638 16000
Tensile Modulus psi D638 130000
Tensile Elongation @Break % D638 4
Flexural Strength psi D790 23000
Flexural Modulus psi D695 900000
Compressive Strength psi D695 19300
IZOD Impact Strength Notched ft-lb/in D256 2.7
Thermal PropertiesUnitsASTMResults
Coeffcient of Linear Thermal Expansion (x 10^-5 in./in./°F) 1.6
Heat Deflection Temp at 264 psi °F 470
Electrical PropertiesUnitsASTMResults
Dielectric Constant @1 MHz 2.5
Dissipation [email protected] MHz 0.0016
Volume Resistivity, 50% RH ohm-cm 2000

NOTE: The property values presented above are typical values intended for reference and comparison purposes only. They should NOT be used as a basis for design specifications or quality control. Contact us for manufacturers’ complete material property datasheets. All values at 73°F (23°C) unless otherwise noted.


  • Bearings
  • Wear strips
  • Bushings
  • Rollers
  • Gears


  • Superior wear resistance
  • High use temperature
  • Outstanding machinability
  • High resistance to abrasion
  • Great mechanical properties
  • High P.V. limit
  • No galling of mating wear surfaces


  • Hydlar™ ZM
  • Hydlar™ ZM
Copyright © 2016 - 2022 Emco Industrial Plastics
澳洲幸运5官网开奖 澳洲10全天一期计划 快乐飞艇历史结果 SG飞艇单双 澳洲10开奖直播视频 澳洲幸运5历史开奖 极速赛车开奖结果大小